Quantcast
Channel: SparkFun Electronics Comments
Viewing all articles
Browse latest Browse all 44542

Customer #39159 on PRT-10217 - LiPo Charger Basic - Micro-USB

$
0
0

Hello, I’d like to comment that the attachment of the microUSB connector is still a problem, nearly 2 years after the first concerned comments. In my case, simply picking up the charger with the cable attached exerted enough force to physically rip the connector with copper solder pads off of the PCB. Note, that this is a copper layer bonding issue, not a soldering issue. I have two small holes showing brown PCB where the copper used to be. These pads are very small (i.e. size of the microUSB solder tabs. Making them larger would improve their bond strength to the PCB material.


Viewing all articles
Browse latest Browse all 44542

Trending Articles