Extremely disappointed with these. I bought a bunch of them assuming that the smaller pads at each end were spaced 0.1" apart for standard pin headers, but they’re spaced much closer together than that and are positively tiny. I was hoping to use a standard servo cable on the input side, plug a motor into the output, and use the spare set of pads on the output that would normally be used for the screw terminal to install a rectifier diode.
My fault for not looking at the eagle files I guess, but from a design standpoint it makes no sense to include a second set of attachment points for wires when there is another slightly larger set of pads right next to them which would work just as well for that purpose.