Kamiquasi on TOL-09325 - Solder Lead Free - 100-gram Spool
It states in the description: Mix: 99.3% Sn / 0.7% Cu. So no, not even close to 60/40.. which generally refers to tin/lead content anyway and this is lead-free solder, as per the title :) Perhaps you...
View ArticleM-Short on DEV-11117 - ATMEGA32U4 Breakout
You are going to have to be more specific. If you have problems with the board feel free to email techsupport@sparkfun.com as well.
View ArticleM-Short on DEV-11364 - LilyTwinkle
Also don’t forget just because its round and purple doesn’t mean you have to use it for e-textiles. You can still solder to the pads, they are just bigger than normal.
View ArticleRyeMAC3 on Sprinter Van Contest Take 2
BEST. VIDEO. EVER. “The sky is your oyster!” – classic. That needs to go on a t-shirt. Stat.
View ArticleElectroGod on According to Pete - Analog to Digital Conversion
Nyquist says in order to recorver any signal you must sample it 2 times de frequency of the signal. So when you aply the Fourier transform to a periodic signal, will be non periodic and discrete in...
View ArticleZoomer on According to Pete - Analog to Digital Conversion
Oh, Pete. For such a strong engineer, you should know that Nyquist said you must sample at GREATER THAN 2f. Equal to is not sufficient.See the comment from TheRegnirps for more info.
View Articlecmat on CAB-09741 - IC Hook with Pigtail
Quite useful for hooking up parts I want to test and not damage by soldering leads.
View Article532nmIsMyFavoriteColor on DEV-11364 - LilyTwinkle
I know. I just thought that one made on a normal circuit board might be cheaper.
View ArticleGus Issa - GHI on DEV-11306 - FEZ Hydra Basic Kit
Did you install the software is in the steps on here? http://ghielectronics.com/support/.net-micro-framework This is a troubleshooting guide as well...
View ArticleCustomer #169916 on WRL-11129 - Si4707 Weather Band Receiver Breakout
Will BNC Connector – Right Angle PRT-10550 fit J4 for the external antenna hook up on this board?
View ArticleCustomer #424915 on COM-09320 - Blackberry Trackballer Breakout
So how’s the project going?
View Articleonedividedbyzero on KIT-11087 - "Uh-oh" Battery Level Indicator Kit
yeah, or telling someones mother died by handing them balloons and a cake that says “sorry your mother died”
View ArticleCustomer #401039 on GPS-08785 - ArduPilot - Arduino Compatible UAV Controller...
hello everybody is it used to control quadcopter ? if yes how can I download the firmware? thanks
View ArticleCustomer #237520 on According to Pete - Analog to Digital Conversion
Pete-O…I enjoy your “According to Pete” posts, good refresher and gets the memory moving. My question is how long, typically, does your posts take to make?
View Articleliudr on DEV-11287 - Arduino Wi-Fi Shield
pylon on arduino forum has traced this to a 100 byte buffer in firmware. There will be no benefit upgrading firmware. You are better off now.
View ArticleCustomer #438423 on SEN-11745 - CMOS Camera Module - 728x488
Are these supposed to get warm when powered. Im powering from a LIPO 3S 11.4 but it doesnt get warm or give a signal. Any ideas ?
View ArticleToni_K on SEN-10264 - Flex Sensor 2.2"
At 180 degrees, you are going to be bending the sensor at the base, which will have a negative affect on the functionality of the sensor and may damage it, so I wouldn’t suggest it.
View ArticleToni_K on GPS-08785 - ArduPilot - Arduino Compatible UAV Controller w/ ATMega328
Yes, this can be used for a quad copter. Check out the links we have posted above for the DIY Drones community. This has instructions and the firmware.
View ArticleToni_K on DEV-08544 - Conductive Thread - 117/17 2ply
You may be right on one or both accounts. The silver can oxidize over time, decreasing its conductivity. Alternatively, if your project is being handled often or has been washed several times, the...
View Article