Kamiquasi on DEV-09530 - OpenLog
Looks good here, using Chrome’s built-in PDF viewer and PDF X-Change.
View ArticleCustomer #339117 on TOL-11702 - DSO Nano V3 - Pocket-Sized Digital Oscilloscope
Thanks for the info. The upgrade was easy. BenF should be the default firmware.
View ArticleCustomer #385051 on SEN-09963 - RFID USB Reader
I’m having trouble getting this to work with my arduino. I have the vcc connected to 5V, the grnd to grnd. and the tx is connected to the rx.I’m using an Arduino Uno. I’m pretty new to all of this....
View ArticleBeagleBoy on PRT-08872 - Mic Preamp
Since the LED is in series with R4, it works out. I just tested my circuit, and with 9V input, the Q1 collector is right at 3V.
View ArticleMetabolicCloth on COM-11719 - Coin Acceptor - Programmable (3 coin types)
are there dimensions available for this?
View ArticleCustomer #428370 on BOB-10859 - L6470 Stepper Driver Breakout
Hello. While I don’t have this board yet (or any dSPIN to play with at all) I can tell you that your problem is a platform problem. Note that the C standard does not offer any guarantees as to the...
View ArticleShahab on DEV-11343 - IOIO-OTG
I remember previous IOIO had a compatible phones list. Does it apply to this version as well?
View Articledavid.kuller on WRL-11600 - RN41-XV Bluetooth Module - Chip Antenna
I have this working with a Lilypad and Lilypad xbee hosting the chip – but only if I use pin 0/1 (rx,tx) of the Lilypad – I have not been able to communicate with the rn41xv using the softwareserial...
View ArticleTimZaman on PRT-11370 - USB Weatherproof Connector - Panel Mount (USB B)
Connections are as follows (not mentioned in the datasheet) (1: Vcc) (2: D-) (3: D+) (4: NC) (5: GND)
View ArticleCustomer #428383 on COM-10080 - Thermoelectric Cooler - 40x40mm
The junctions in TECs are of Fe strips soldered on the opposite ends of the semiconductor cubes and are held in place by the ceramic plates.The Thermal expansion becomes a major factor when you try to...
View Articlen on COM-11644 - OpenSegment Serial Display - 20mm (Red)
I have been completely unable to upload code to either of two copies of this unit.When I use the FTDI basic breakout, the reset occurs, and avrdude initially seems to communicate successfully with the...
View Articlezouze on DEV-11113 - Arduino Pro Mini 328 - 5V/16MHz
is this compatible with voltage divider shield found here: http://www.ebay.com/itm/150993542084 ?
View ArticleAIW on WRL-11129 - Si4707 Weather Band Receiver Breakout
BBB….I’m using a right angle nearson antenna PN: L181-150R with my BNC connection on my Si4707 board. It’s different in shape than this board but same setup. These are about $12. I’ve also used many of...
View ArticleCustomer #399345 on WRL-10050 - WiFly GSX Breakout
Im trying to power the device using a current-controlled power supply. The is problem is that it is not written in the manual how much normal current the device consumes. From my tests it seems it...
View ArticleCustomer #428403 on LCD-11062 - Color LCD - Breakout Board
Hi to everybody! I got this product and connected it to my mbed ( LPC2368 ). I tried to run the example ( Helloworld ) posted on mbed.org, but it didn’t work. The unique result I obtained was to turn...
View Articledavid.kuller on DEV-08937 - LilyPad XBee
I have this working with a Lilypad and rn41xv hosted on the card – but only if I use pin 0/1 (rx,tx) of the Lilypad – I have not been able to communicate with the rn41xv using the softwareserial...
View Articleoosnoopy on Fighting Walrus Radio - iPad/iPhone UAV Base-station
Why are they wasting time on iOS based devices…
View Article